The main objective of the adjustment process
Is to improve the room temperature and humidity to be as follows: -
1 - room temperature in a refrigeration 22 + - 2 ° C
2 - room temperature in the heating 28 + - 2 ° C
3 - humidity 50 + 5%
Idea Allasasah: -
Adopt the fundamental idea in cooling the heat transfer between the chilled water (iced) and the air temperature depends on the area (outside air temperature)
In this case uses freon as a refrigerant.
1 - Piston Compressor: -
Freon is shipped from the cylinders to him in the form of gas and compresses freon even come out of it with high pressure and high temperature up to 50 degrees Celsius.
2 - condenser Condenser Or Heat Exchanging Pipes: -
It is a Copper Pipes and around the fins of aluminum and called Copper Tubes Aluminum Fins and passes freon in these pipes copper with high temperature and passes them air are heat transfer between air and freon are air heating and distributed to the fins Fins and expel hot air to the outside, which reduces the temperature Freon-based cooling process and come out freon in the form of a liquid.
3 - expansion valve Expansion Valve: -
Freon passes by in and out of the liquid in the form of spray Spray as a result of a Throttling strangulation process with low temperature and low pressure.
4 - Evaporator Evaporator: -
It is a Copper Pipes and around the fins of aluminum and called Copper Tubes Aluminum Fins also "like Condenser and passes freon in these pipes copper low-temperature and passes them air to be cooled, which has been withdrawn from the room where the air passes Ali Pipes Freon-cooled and is distributed on the Fins than increases the surface area of heat transfer between the air and the freon pipes
And finally "be paid by fan air into the room to be adapted.
And finally "freon enters back on the plunger after his transformation from liquid to gas so as not to damage the piston and continue role
